Module quiz

5 questions

To avoid rapid changes in a spline’s inflection point, which of the following best practices should be considered?

(Select one)
Select an answer

Which type of Construction geometry can be used to create a plane that is equally spaced between two parallel faces?

(Select one)
Select an answer

After the Rectangle tool is launched in an active sketch, which of the following should be done to switch from 2-Point Rectangle to Center Rectangle?

(Select one)
Select an answer

Which of the following is a candidate for a Path in the Text On Path object?

(Select one)
Select an answer

Where can 3D sketching be enabled in an active sketch?

(Select one)
Select an answer

5/5 questions left unanswered