Run a Refined Analysis on the Bridge in InfraWorks

00:14

Now, I am going to return back to the analysis tool, the structures panel.

00:17

The tool next to it there is the Refined Analysis tool.

00:21

When I left click on that, I can run this again.

00:24

Now you do have options here, including the model type, where there's grillage or offset girder, tub girder, span start and end,

00:33

aspect ratio, structure properties, and then your information down below that.

00:39

I'm going to start the analysis on that.

00:42

And again, this takes a while. So, we'll come back when this is completed.

00:46

And here you can see that analysis is complete.

00:50

You can cycle through the different analysis that this tool provides using these arrows.

00:55

And you'll get kind of a preview of those analysis.

00:59

Or you could come down here to the View Report or this is really meant for moving this over to Open in ASBD.

01:07

Let me click on that.

01:08

Now, we are not going to cover that tool at this point.

01:12

But you'll see the effect that this has.

01:16

It brings all of that information in about that bridge.

01:19

And you can see that there's quite a bit of detail that you can get to for each part of this bridge.

01:27

So, I'm going to close that at this point.

01:29

We will look at another time.

01:32

I'm going to close the analysis and go back to our design.

01:40

I'll left click off to the side so that we can get our design back.