Transcript
00:00
MARTHA HOLLOWELL ORCUTT: In this course,
00:02
we're going to investigate some tools to help us run
00:05
duct and pipe in tight spaces.
00:08
This is part of the design development phase of a project.
00:11
And catching interferences now will save a lot of time
00:15
when preparing for fabrication and construction.
00:19
We are specifically in the learning path
00:21
of mechanical duct and pipe, and we're
00:24
going to focus first on running interference checks.
00:28
We will then look at the interference check
00:30
tool in Revit and use it to correct several clashes.
00:34
Once we have a result from the interference check,
00:37
we will then clean up the interferences.
00:40
In this case, focusing on using Parallel Pipes tool to quickly
00:45
add and modify pipes in a tight space,
00:48
and modifying ducts by connecting
00:50
fittings to fittings, which helps us avoid clashes
00:53
while taking up the least space possible.
00:57
Once we've cleaned up interferences,
00:59
it's a good idea to size the duct and pipe again.
01:02
Making modifications to get around interferences
01:05
can cause a change in flow.
01:08
In this set of videos, we will work with the interference
01:11
checking, create and modify parallel pipes,
01:15
and change short runs of ducts so fittings connect to fitting.
00:00
MARTHA HOLLOWELL ORCUTT: In this course,
00:02
we're going to investigate some tools to help us run
00:05
duct and pipe in tight spaces.
00:08
This is part of the design development phase of a project.
00:11
And catching interferences now will save a lot of time
00:15
when preparing for fabrication and construction.
00:19
We are specifically in the learning path
00:21
of mechanical duct and pipe, and we're
00:24
going to focus first on running interference checks.
00:28
We will then look at the interference check
00:30
tool in Revit and use it to correct several clashes.
00:34
Once we have a result from the interference check,
00:37
we will then clean up the interferences.
00:40
In this case, focusing on using Parallel Pipes tool to quickly
00:45
add and modify pipes in a tight space,
00:48
and modifying ducts by connecting
00:50
fittings to fittings, which helps us avoid clashes
00:53
while taking up the least space possible.
00:57
Once we've cleaned up interferences,
00:59
it's a good idea to size the duct and pipe again.
01:02
Making modifications to get around interferences
01:05
can cause a change in flow.
01:08
In this set of videos, we will work with the interference
01:11
checking, create and modify parallel pipes,
01:15
and change short runs of ducts so fittings connect to fitting.
