Create views on a detailed drawing

00:02

In this video, will create views on a detailed drawing.

00:06

After completing this step, you'll be able to create a section view and a detailed view.

00:13

In fusion 360, we want to carry on with our coupler for production drawing.

00:17

We've already added our base view in our projected views.

00:20

So now we're going to take a look at creating a section view and a detailed view.

00:24

We're going to start by creating a section view and we need to select the view that we want to use and then we need to draw our section line.

00:32

This can be done by snapping to geometry or we can have the line extends all the way through the part.

00:38

And once we're happy with the line we can either use the green check mark to continue or right click and select continue.

00:45

Then we need to drag it to a new location, change any of the parameters in the drawing view dialog that are needed or say okay.

00:53

If the note is overlapping another view, we can simply drag it to a new location and then we can left click anywhere else in the drawing.

01:02

Next let's take a look at creating a detailed view.

01:05

Once again we need to select the drawing view and then in this case we need to select the center point for a circle that's going to be drawn,

01:12

and we're going to go ahead and drag this out just large enough to capture the entire spine and the outside of the coupler.

01:18

And then we need to place this view.

01:21

Once place we can modify the parameters such as the scale, whether or not we want to change the style or the tangent edge display.

01:29

We're going to say okay, and once again, I'm going to reposition the B in notation until I'm happy with its position.

01:36

Now that we have our section view in our detailed view. Let's go ahead and save the drawing before moving on.