Learning

Certification

Certification overview

Architecture, Engineering & Construction

Design & Manufacturing

Media & Entertainment

Support & Policies

Learning

Module quiz

5 questions

Which of the following steps should precede a chip-breaking Drill operation for holes on a part?

(Select one)

Spot drill the target holes.
Use 2D Bore for the target holes.
Fill target holes with coolant.
Use Thread for the target holes.

Select an answer

A major advantage of the 2D Adaptive Clearing toolpath is that it:

(Select one)

Minimizes tool wear by keeping a consistent chip load.
Results in a smaller program size.
Uses only linear movements.
Uses the least amount of the tool’s flute length possible.

Select an answer

When selecting stock size, it is important to choose a size that is:

(Select one)

Smaller than the finished part size.
No more than .25in smaller than the finished part size.
Equal to the finished part size.
Larger than the finished part size.

Select an answer

When editing tool parameters, what does the ‘fx’ indicate for a specific field?

(Select one)

The parameter is a function of another value.
The parameter is fixed and cannot be changed.
The parameter is defined by the tool vendor.
The parameter is for reference and does not affect calculations.

Select an answer

When selecting geometry to define a 2D Contour toolpath, clicking the red arrow after selecting the contour will:

(Select one)

Force the tool to stop a feed movement.
Flip which side of the selected geometry the tool cuts on.
Insert a tab on the part parallel to the arrow’s direction.
Cause the tool to stop at that point and begin cutting in the opposite direction.

Select an answer

5/5 questions left unanswered