Module
20 min.
Running an MEP model analysis in Revit
Module overview
Welcome to the Running an MEP Model Analysis in Revit module. In this module, we will build upon “setting up MEP spaces” modules. You will review and adjust space settings to prepare for heating and cooling load analysis, then generate and review heating and cooling analysis report.
This module takes approximately 20 minutes to complete. By the end of the module, you should be able to:
- Review and adjust space settings.
- Run heating and cooling analysis.
- Review analysis report.
Module pre-requisites
This module requires user-level knowledge of Dynamo and is focused on best practices and its industry applications. If you don't have experiences with this product, we recommend you to take foundational training using one of the resources below:
- Built-in tutorials, available via in-product Help
- eLearning Partners
- Authorized Training Centers
Before you start
- Please make sure you have the Revit software loaded.
- If you have technical difficulties, please reach out to product support.
Module downloads
These downloadable resources will be used to complete units in this module: