Module

20 min.

Manufacturing your Nesting results

Module overview

Having completed your nesting study, this content series will cover the workflow steps required to prepare the nested components for manufacture using both milling and cutting operations.

This content takes approximately 20 minutes to review. During the duration of this content, you will be:

  • Inventor Nesting Push: CAM Cutting
  • Inventor Nesting Push: CAM Milling and Cutting

Prerequisites

This content series requires user-level knowledge of Inventor and is focused on best practices and its industry applications. If you don't have experiences with this product, we recommend you to take foundational training using one of the resources below:

About the author

This content series was recorded by one of the creators of Inventor Nesting - Bob Van Der Donck.

Before you start

  • Please make sure you have the Inventor software loaded.
  • Download Inventor Nesting and Inventor CAM from your Autodesk Account (available only for subscribers of Design and Manufacturing Collections).
  • If you have technical difficulties, please reach out to product support. 

Module downloads

These downloadable resources will be used to complete units in this module:

Module outline

  • Inventor Nesting Push: CAM Cutting
  • Inventor Nesting Push: CAM Milling and Cutting