Module

10 min.

Create a Factory Layout Simulation Using Process Simulator

Module overview

This module will provide an introduction on creating a factory layout simulation using Process Simulator, referencing Factory Design Utilities assets. With the simulation created, this module will also detail how to run the process simulation and review the results.

This module takes approximately 10 minutes to complete. By the end of the module, you should be able to:

  • Understand how factory assets can be utilized to create a new production simulation using Process Simulator in ProModel
  • Modify the production parameters
  • Analyze the simulation results and modify the production layout

About the author

This module was developed using the following Autodesk University Class, which was created by Aaron Nelson, Keith Vadas, and Andrew Schild.

Module outline

  • Process Simulator