When the Selection of Sections dialog box for a specific design group does not contain any sections, the Code group design with Optimization for such group will:

(Select one)

Fail
Do not change the section
Search in all sizes of section type used in members contained in the group
Search in all section types contained in the first available section database

Select an answer

In the tables of results in Robot, it is possible to:

(Select one)

Remove unnecessary columns
Add additional columns
Filter the contents
All of the above

Select an answer

When running calculations of RC slab required reinforcement:

(Select one)

It can be done for selections of panels from the model
It must be performed together for all panels
It must be performed story by story
It must be performed panel by panel

Select an answer

Where are the main directions of reinforcement in panels defined?

(Select one)

It is always local X for panels
In local coordinate systems of panels
In the reinforcement types assigned to panels
It is always global X for slabs and global Z for walls

Select an answer

Where are buckling length parameters for members defined?

(Select one)

In Job Preferences
In the "Member Type" definitions
In design Groups
In the "Configuration" of steel design calculations

Select an answer

When the Code group design with Optimization according to weight was performed, the optimum section size with the smallest weight and sufficient strength is:

(Select one)

The one with the blue exclamation mark
The first one on the list
The one with the OK sign
The last one on the list

Select an answer

When Member verification is run for the list of members, the results are given:

(Select one)

Individually for each member
For the member with the highest efficiency ratio
For as many members as the number of different section sizes in them

Select an answer

Can the specific part of the model be isolated in a new graphic viewer?

(Select one)

Yes
No

Select an answer

What is the default number of points for the output of results in the table of forces in Robot?

(Select one)

10
2
3
11

Select an answer

How can diagrams on bars be customized in Robot?

(Select one)

Displayed filled
Displayed with descriptions
Displayed fenced
All of the above

Select an answer

Is it possible to modify the predefined default reinforcement type?

(Select one)

Yes
No

Select an answer

Where are the code-specific parameters for RC slab required reinforcement defined?

(Select one)

In the Panel Calculation Model
In the Analysis Type dialog box
In Preferences
In the Plate and Shell Reinforcement Type

Select an answer

Analysis and Design - Quiz

Analysis and Design - Quiz

When the Selection of Sections dialog box for a specific design group does not contain any sections, the Code group design with Optimization for such group will:

In the tables of results in Robot, it is possible to:

When running calculations of RC slab required reinforcement:

Where are the main directions of reinforcement in panels defined?

Where are buckling length parameters for members defined?

When the Code group design with Optimization according to weight was performed, the optimum section size with the smallest weight and sufficient strength is:

When Member verification is run for the list of members, the results are given:

Can the specific part of the model be isolated in a new graphic viewer?

What is the default number of points for the output of results in the table of forces in Robot?

How can diagrams on bars be customized in Robot?

Is it possible to modify the predefined default reinforcement type?

Where are the code-specific parameters for RC slab required reinforcement defined?