Participate in Assembly and Drawing sections not being honored with iPart members in Inventor

Autodesk Support

Oct 8, 2023


Products and versions covered


Issue:

"Participate in Assembly and Drawing sections" not being honored with iPart members in Inventor.  When opening the document settings for a member, it is grayed out.

Causes:

iPart members are created using the standard templates and leverage the document settings set inside of those templates.

Solution:

Adjust the document settings inside of the templates and regenerate the members:
  1. Open the standard.ipt template being used by the project file.
  2. Under the Tools tab select Document Settings.
  3. Check "Participate in Assembly and Drawing sections" under the modeling tab.
  4. Save the template
  5. Go to the parent iPart and generate the members again.
    • You may need to do a rebuild all to force Inventor to pick up that a change has occurred.
Note - If your templates are locked down, you can create a new project file with other templates so that you don't edit your specific templates that are used in other areas of the software.  This way you can use only these templates when generating iPart members.

Products:

Inventor Products;


Was this information helpful?


Need help? Ask the Autodesk Assistant!

The Assistant can help you find answers or contact an agent.


What level of support do you have?

Different subscription plans provide distinct categories of support. Find out the level of support for your plan.

View levels of support