Is the material data valid using a melt temperature outside the tested range in Moldflow

Autodesk Support

Feb 28, 2025

Products and versions covered

The material UDB is tested in the range of 200-220 Deg C for all key properties like Shrinkage (CRIMS), PVT and Viscosity in Moldflow.

If the analysis is run at melt 240c how does this affect the other properties not tested at this temperature.

Material data tested in a temperatures range will extrapolate data for temperatures outside of the range.

Moldflow Insight;

Was this information helpful?

Need help? Ask the Autodesk Assistant!

The Assistant can help you find answers or contact an agent.

What level of support do you have?

Different subscription plans provide distinct categories of support. Find out the level of support for your plan.