Module
10 min.
Generative Design Connected Learning Part 5: Preview and Generate
Module overview
Step through leveraging Pre-check to ensure models will run, Previewer to get initial insight into what outcomes may look like, and submitting jobs for generation.
Learn the following skills:
- Pre-check and its outputs
- How to change Previewer settings
- Submitting for generation
About the author
This content was created by Apolo Vanderberg, Autodesk Designated Specialist and Instructor focused on CFD and Generative Design.
Before you start
- Please make sure you have Autodesk Fusion software loaded and installed
- If you have technical difficulties, please reach out to product support.
Module downloads
These downloadable resources will be used to complete units in this module: