Apply and Explore Reinforcement Cover

Module overview

The objective of this module is to understand how we set up rules to host reinforcing in a concrete element. When you think about a concrete element, we think about a few things. We think about what that element's job is (a column, floor, or a structural foundation). Knowing what the element contributes to a structure, we then think about the actual concrete (cast in place, precast, PSI, and tensioning). With all of this we can start to think about how this element is going to host reinforcing. And, how much concrete do we need between the steel rebar and the outside face of the concrete. In other words, the concrete cover.

This module takes approximately 15 minutes to complete. By the end of the module, you should be able to:

• Explore Concrete Cover
• Add a new Cover Setting
• Add Rebar to an element using the concrete cover settings

About the author

This module was created by Eric Wing.

Befor you start

• Please make sure you have the Revit software loaded.
• If you have technical difficulties, please reach out to product support. 

Module outline

• Introduction
• Exploring Cover Settings (4:13)
• Adding a New Cover Setting (2:47)
• Adding Rebar (5:09)
• Apply and Explore Reinforcement Cover - Quiz
• Learn More or Get Help on This Topic