• InfraWorks

Adjust walkway parameters to control physical distancing in InfraWorks Mobility Simulation

Adjust walkway parameters to control physical distancing in your InfraWorks simulation model.


00:03

In InfraWorks, there are two ways to adjust walkway parameters to control physical distancing in your Mobility Simulation model.

00:11

In the first method, the walkway is divided into shorter sections and the Private functionality is enabled.

00:18

These settings can be accessed by right-clicking and selecting Adjust to open the Adjust dialog.

00:25

Selecting Private means that only one pedestrian can enter any given walkway section at a time, thus controlling pedestrian traffic flow.

00:33

In the first image, you see the result of these settings, with people spaced accordingly.

00:40

The second way you can adjust walkway parameters for distancing purposes is to set the Capacity value, also from the Adjust dialog.

00:48

In this case, the walkway is not divided into sections, as previously,

00:53

but the Capacity is set to 3, so that no more than 3 people can enter the walkway at once, as shown in the second image.

01:00

You can use either of these two methods to limit the number of people on walkways

01:05

and control physical distancing in your Mobility Simulation model.

Video transcript

00:03

In InfraWorks, there are two ways to adjust walkway parameters to control physical distancing in your Mobility Simulation model.

00:11

In the first method, the walkway is divided into shorter sections and the Private functionality is enabled.

00:18

These settings can be accessed by right-clicking and selecting Adjust to open the Adjust dialog.

00:25

Selecting Private means that only one pedestrian can enter any given walkway section at a time, thus controlling pedestrian traffic flow.

00:33

In the first image, you see the result of these settings, with people spaced accordingly.

00:40

The second way you can adjust walkway parameters for distancing purposes is to set the Capacity value, also from the Adjust dialog.

00:48

In this case, the walkway is not divided into sections, as previously,

00:53

but the Capacity is set to 3, so that no more than 3 people can enter the walkway at once, as shown in the second image.

01:00

You can use either of these two methods to limit the number of people on walkways

01:05

and control physical distancing in your Mobility Simulation model.

Was this information helpful?